birdman Posted December 3, 2005 Report Share Posted December 3, 2005 sorry, i cant get on during the week but like i said right where is circled the hinge comes down soo low that nothing can be in that area, my friend still has my drawing but ill make a new one and pm you that so not to keep you waiting. Quote Link to comment Share on other sites More sharing options...
J Posted December 3, 2005 Report Share Posted December 3, 2005 i like that design, i only have one concern. Is it possible to put so much stress on the top bolt that it may after time shear off? I know you'd be pushing the top bolt to the outside and the bottom bolt to the inside if you get pressure on that side. Can you guys follow my thoughts? Or should i make a pic?> Quote Link to comment Share on other sites More sharing options...
birdman Posted December 3, 2005 Report Share Posted December 3, 2005 i follow, couldnt really see it happening but its never been done so who knows? the design i have spreads the force evenly so i know it'll be fine. Quote Link to comment Share on other sites More sharing options...
AWeb80 Posted December 3, 2005 Author Report Share Posted December 3, 2005 here is the new one....based off of Birdman's Design. Quote Link to comment Share on other sites More sharing options...
J Posted December 4, 2005 Report Share Posted December 4, 2005 here is the new one....based off of Birdman's Design. i don't really follow that mount :?: Quote Link to comment Share on other sites More sharing options...
birdman Posted December 4, 2005 Report Share Posted December 4, 2005 i know this is getting really repititive but its important for there to be the same amount of clearence as in my drawing here because the trunk arm comes down and back through here and i dont quite see how the total length came out to be 8" not 6"?? Quote Link to comment Share on other sites More sharing options...
AWeb80 Posted December 4, 2005 Author Report Share Posted December 4, 2005 O, ok....I thought your dim. were just "reference" dim...my bad. I made them thicker for strength...i'll make them to your dims then. Quote Link to comment Share on other sites More sharing options...
birdman Posted December 4, 2005 Report Share Posted December 4, 2005 ok, sorry for the confusion, i ment the actual pic was not the right size but it was just there to show you where the demensions were. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.