Jump to content

Window Regulator and Motor Replaced but still won't go up.


Recommended Posts

Posted

Yeah so I have a 95 CS 2dr I just replaced the window motor on the driver side. New motor, old regulator and reinstalled everything. power and switch works fine up and down when I tested before putting back in.  but for some reason it doesn't want to go up after I bolt it in. If I take out the top right corner bolt it goes up just fine. And as you can see the hole doesn't quite want to line up in the fully up position. All the way down the holes lines up fine. Nothing seems to be binding but can't really tell. The assembly shifts slightly between directions. Was thinking about just drilling out the hole so it lines up better. Any other suggestions??

17301314291347400960659689613480.jpg

17301314935918314356629343148654.jpg

Posted

Just to update I decided to drill the hole out a lil and bolt it and everything is fine now 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...