Leaderboard

Got her running boys!! Not only that, she runs tip top again!! It was timing all along. Fabbed some tools in my father in laws shop to replicate those in the Kent moore kit and worked like a charm. A big thank you to those who offered help and guidance through my first real foray into the 3.4L dohc joys and frustrations. It's been better than 12 yrs since my z34 and I never tackled projects like gaskets or timing on it. This is really a great group!!

*It basically adjust the steering feel when going thru a parking lot and then tightens up when on the highway or Interstate*. almost......lol, not quite.... the sensor is there to 1. disengage the a/c .... 2. send a signal to the ecm to raise the engine rpm when the vehicle speed is so slow that the engine rpm is to low to adequately assist the needed power steering pressure. When the pressure in the system drops to a pre determined pressure that switch opens, the ecm *sees* that & raises the engine rpm to increase the pump rpm & power steering pressure. The sensor is referred to as Idle Speed Power Steering Pressure Switch

Hello, I’m new here but wanted to take the first step toward posting. As you can see in the title I have a 1991 Grand Prix. I just finished getting my DIY exhaust mocked up and ready to weld and I will try to post pictures of it soon as well as other things. I have all new KYB struts and just ordered the rest of the parts I need to build rear coil overs, with the intention of lowering the car a lot. Will start a thread on that soon. Glad to be here.

Pretty sure every one of these cars use this

yes indeed...

Check the obvious things, is the brake fluid level full? is the switch used to measure it working? Same goes for the parking brake pedal, try lifting on that to see if that causes the BRAKE light to go out High mount won't cause any of that on these cars. As for the ABS, yeah you need an appropriate scantool to read those codes. I use both a Tech1 or Tech2 to pull those codes, if you're anywhere near Pittsburgh I could pull them for you. Likely you have a couple separate issues, but on a 93' the ABS light is a non critical light, you just won't have any anti-lock is all.

Does anyone know if the 91-93 Z34's uses a speed sensor mounted on the steering racks? I know the GP and Cutlass did. It's part # 10096157/10204102 if they used them. Thank you.

It's a misconception that one or all need to *go to* Birchmount Spring here near to me in Toronto to get a replacement steel leaf spring for their car. Any spring shop can fab up a replacement multi leaf arrangement, the shop just needs to know what spring rate you want, how many leaves you require (the fewer the better ..more than 1 leaf), the total length of the leaves, the ride height you're looking for. What you see below is what is under my car...the shop I approached arched the 2 leaves to the right height I wanted, seeing as this is a transverse spring each leaf on each side has to be tweeked to ensure that each side of the car's ride height is identical.

Gotcha. Thank you for the accurate description. I was just making a guess. So...the Z34's do use this sensor as well then?

Great news!

This one has your name al over it! Being California car it should be reall clean https://www.facebook.com/marketplace/item/290176733382939/?mibextid=6ojiHh