Jump to content

94 Door Wire Harness


Mstg007
 Share

Recommended Posts

I am still dealing with my automatic door locks. I have replace both apertures. I was looking around for a door relay in this mess, but I found some corrosion and wires that are rusted apart. As I would wiggle the harness around I could hear the door lock sound. Any ideas on this? Is there a good way to clean out these parts?

 

Thanks!

 

http://tinypic.com/r/311njig/9

 

http://tinypic.com/r/2ll0yuw/9

Link to comment
Share on other sites

  • 4 weeks later...

If the wires are corroded apart you have to cut them at the corrosion and splice in a bridge. The connector shouldn't be a problem unless it's melted together, which in that case the best way to deal with it would be to get a new connector. You would have to depin the old one and use the one from a yard car.

 

Do you have pics of where it is corroded?

Link to comment
Share on other sites

The wire is completely broken out of the connector. You could very well de-pin and cut a wire out of a salvage yard rig and splice it in (and that is the proper repair), but honestly I would just cut the same wire on the other side of the connector and splice them together directly (with solder and heat shrink, NOT BUTT CONNECTORS/SCOTCH LOCKS). It's not like you're going to be needing to disconnect that connector and separate the harnesses frequently.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...