I recently purchased a 1999 Regal, the car is in relativity good shape. I have one problem with the interior. The cup holder is "missing", and the only thing left is a black plastic piece (that pivots up or down) and the cover.
Is this something I can purchase through General Motors? I have a feel I have to purchase the entire console, which I am not interested in doing.
Thanks,
BBVISION
check out Ebay?
maybe this can help: http://www.ebay.com/sch/i.html?_from...All-Categories
common problem...they break easily. Best bet is to try junkyards. I found a tan one and painted it with gray interior paint and it matched perfectly. I looked into getting one at a dealer a little while ago and hella expensive. I'll have to see if I can dig up the part number. You need the whole trim piece for the top of the console, you can't just get the cupholder part. Bad thing is even I broke this one and i'm very careful. Most was missing when I got the car. This one still works, I just have to be careful pulling it out and putting it back.
1998 Buick Regal GS
1987 V10 (SM465/LT1-L31 TBI)
Former w-bodies - 1996 GTP Special Edition, 1991 GTP 5-speed
I'm confused how you would just swap the cupholder, but maybe it can be doneOriginally Posted by Jprice90
1998 Buick Regal GS
1987 V10 (SM465/LT1-L31 TBI)
Former w-bodies - 1996 GTP Special Edition, 1991 GTP 5-speed
Thanks for the help! I was gone on vacation for the last week!
1999 Buick Regal LS - 3.8L 158,900 miles
I may have a usable one in the garage. I believe one of the side wings on it was broken, but I was going to swap it over. It is grey.
<br />1998 Olds Intrigue | 1993 Bonneville SSEi SOLD!| 1996 Acura Integra GSR 4dr
Last one on EBay went for $200 shipped. New is $300.+ (retail)
I have seen a few cars in local junkyards, but no good ones to be found.
There was a complete console on EBay for $180 shipped - didn't sell, could be re-listed.
Last edited by MySlowRegal; 09-13-2011 at 10:49 PM. Reason: Spell much
John
99 Regal LS
Green/grey leather
TSW Crofts - gunmetal/machined
12" F body front brakes
GMPP bars and rear STB
Custom trailing arms
Just checked the one I have and the cup holder is actually fine, just had to re-seat the spring for the side panel. It is missing the trim around the shifter though and no traction button panel, but the rest is there and functioning.
Dirty in the picture, but i did clean it up.
This is what the issue was. You can kinda see the spring hanging loose there. I have it fixed, just no new pictures of it. Works like it is supposed to.
I only want $50 Shipped US if interested.
I didn't see your post until now, I apologize.
I just bid on one on EBAY, does anyone have directions on how to change this out?
1999 Buick Regal LS - 3.8L 158,900 miles
Posting Permissions
Reply With Quote
